2004年1月21日 · The stand has no holes in the feet for bolting it to the floor or adding rubber/leveling feet, to me an unbelievable oversight. Leveling the lathe/stand so all 4 feet sit firmly on the ground is accomplished via loosening up every one of the numerous bolt head screws, and shimmying the entire contraption around, then retightening them.

2002年5月1日 · *Drawing up a work plan is most important. By the time the plan is complete, I’ve built the entireproject in my head. For an unfamiliar technique, I take my time and think things through.” “I start with a three-ring binder with dividers.

2005年1月27日 · Re: Question on Osage Orange color Change. John Lucas Barry I can't say for sure because I've never repaired an Osage Orange piece.

2003年11月1日 · “Guess I’ll have to quit woodworking to save the forests. If I had to kill what I eat, I’d be a veg-head, but nothing is like Mahogany in my book.” “An extremely large amount of timber of all species in the world is made into pallets. In the U.S., pallets consume more trees than paper or the building industries.

Lathes Head-to-Head: Powermatic 3520 vs OneWay 1640. by Jerry Hall I bought a 3520a in August. I am a serious beginner and have done a lot of turning, but a beginner nonetheless,so take that into account in my remarks. I did , however, do a …

2025年1月11日 · “I have tried to structure my shop time as any other job. I get home, have down time and supper with my family, then head to the shop and work until 10 or 11pm. My family is well understanding of my efforts, but time management is essential.” “When I retired, I had visions of everyday shop time building unique items.

Johan uses a home made fitting. He had a large hex head hollow fastener that he had milled to create a smooth end, then the complementary nut was also hollowed out, leaving about 50% of the thread. The hollow allows for the capture of the hex head through the bag. Two rubber washers and a metal washer sandwich the coupling arrangement.

The stand has no holes in the feet for bolting it to the floor or adding rubber/leveling feet, to me an unbelievable oversight. Leveling the lathe/stand so all 4 feet sit firmly on the ground is accomplished via loosening up every one of the numerous bolt head screws, and shimmying the entire contraption around, then retightening them.

The Hammer arbor will not accept a dado blade or molding head. The maximum blade diameter for most cabinet saws is 10" which will give a 3.625" depth of cut. With a 10" blade in the B3, the cut is 2.75". To achieve a 3.625" depth, a 12" (300mm) blade is required.

2004年12月5日 · Re: Question on Millers Falls planes. Stephen Kirk in Quakertown, PA >I remember looking at and seeing phillips head screws on the frog adjustment, so by the review on the link you gave, it's probably a Type 5.