[Martyn] Posted a three part series, VeroBoardUino, over at his blog about moving your Arduino project to a soldered breadboard. Next post he will be covering more on the software end of things ...

Before opening the Arduino software, wire up the Arduino according to the circuits page using the 8MHz minimalist breadboard circuit but with a 10k pull-up resistor on the reset pin (physical pin 1).

[Aniss Oulhaci] demonstrates this with a simple HF SDR receiver built on a breadboard. An Arduino is used to control the SI5351 clock generator, which in turn is controlled by the same program ...

Compatible with Arduino and Raspberry Pi, it can almost meet all your needs. (Without Microcontroller Board) Breadboard and Power Supply Modules-Include various LEDs, resistors, buttons ...

The below circuit diagram shows the complete hardware wiring setup of the Arduino-based Smart Walking Stick for the Blind ...

Want to build a complex circuit-based project with your ... cables to interface the different parts of your Arduino project ...